User's Manual

Advanced RF Technologies, Inc.

RSS-GEN, Sec. 7.1.2 – (transmitters)

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and

maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio

interference to other users, the antenna type and its gain should be so chosen that the equivalent

isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.

Conformément à la réglementation d’Industrie Canada, le présent émetteur radio peut fonctionneravec

une antenne d’un type et d’un gain maximal (ou inférieur) approuvé pour l’émetteur par Industrie Canada.

Dans le but de réduire les risques de brouillage radioélectrique à l’intention desautres utilisateurs,

il faut choisir le type d’antenne et son gain de sorte que la puissance isotroperayonnée quivalente (p.i.r.e.)

ne dépassepas l’intensité nécessaire à l’établissement d’une communication satisfaisante.

RSS-GEN, Sec. 7.1.2 – (detachable antennas)

This radio transmitter (identify the device by certification number, or model number if Category II)has been

approved by Industry Canada to operate with the antenna types listed below with the maximum permissible

gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list,

having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this

device. (Max. antenna gain : 3 dBi, Antenna type : OMNI ANTENNA)

Le présent émetteur radio (identifier le dispositif par son numéro de certification ou son numéro de

modèle s’il fait partie du matériel de catégorie I) a été approuvé par Industrie Canada pour fonctionner

avec les types d’antenne énumérés ci-dessous et ayant un gain admissible maximal et l’impédance requise

pour chaque type d’antenne. Les types d’antenne non inclus dans cette liste,ou dont le gain est supérieur

au gain maximal indiqué, sont strictement interdits pour l’exploitation de l’émetteur.

RF Radiation Exposure

This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 30 cm between the radiator

and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter. RF exposure will be addressed at time of installation and the use of higher gain antennas

require larger separation distances.

Use of unauthorized antennas, cables, and/or coupling devices not conforming with

ERP/EIRP and/or indoor-only restrictions is prohibited.

Any changes or modifications not expressly approved by the party responsible for compliance

could avoid the user's authority to operate this equipment.

Home/ personal use are prohibited

Only 50 ohm rated antennas, cables and passive equipment shall be used with this remote. Any

equipment attached to this device not meeting this standard may cause degradation and

unwanted signals in the bi-directional system. All components connected to this device must

operate in the frequency range of this device.

Only 50 ohm rated antennas, cables and passive components operating from 150 - 3 GHz shall

be used with this device.