User's Manual Part 2

Advanced RF Technologies, Inc.
58
6.2.2.3 Wall mounting an ADX Remote Module
 Mount procedure
- The following steps should be followed while mounting the Remote Module
 Verify that the RU and Mounting hole are in good condition
 Separate the wall mount bracket from the Sub-RU
 Placed the wall mount bracket against the wall and mark off the mounting holes
 Drill holes(4holes, 6Φmm) in the installation surface then insert the enclosed anchor bolts
 Bolt the mounting bracket to the wall
 Install the Sub-RU to the mounting bracket
 Fasten the Sub-RU to the mounting bracket using the included screws
 Verify that the Remote Module is securely attached
 Connect the Antenna cable
 Connect the Power
 Connect the Optic cable (if applicable)
Figure 6-7 Remote Module Wall Mount Instructions