User's Manual

Advanced RF Technologies, Inc.

6.2.3 ADX-H-OEU Installation Procedure

CAUTION: ADX-H-OEU should be installed inside building only.

6.2.3.1 Installing a ADX-H-OEU in a Rack

The ADX-H-OEU mounts in a standard 19” (483mm) equipment rack. Allow clearance of 3” (76mm) front and

rear, and 2” (51mm) on both sides for air circulation. No top or bottom clearance is required.

x Consideration:

- Four mounting holes are located on 4 corners of ADX-H-OEU to attach it to the 19” rack. The ADX-H-OEU

must be securely attached to support the weight of the unit.

x Mount procedure

- The following steps should be followed while mounting the ADX-H-OEU

! Detach the wall mount brackets located at the base of the ADX-H-OEU

! Verify that the OEU and mounting hole are in good condition

! Screw the ADX-H-OEU to the 19”rack

! Make sure the ADX-H-OEU is securely attached

! Connect the GND cable

! Connect the RF cable

! Connect the Power

! Connect the Optic cable