User's Manual

Advanced RF Technologies, Inc.
39
- Size: 19.0 x 12.0 x 2.6 inches (482 x 304x 66 mm)
- Weight: 9.9lbs (4.5 kg)
- Power Input: 110V or 220VAC, selectable by switch
3.2.3.2.1 LEDs
ADX DAS has the following LEDs on the front of the RU PSU as shown below in Figure 3-33.
POWER
CHG STS
LOW BATT
AC
F
AIL
DC FAIL
Figure 3-33 RU PSU LED
Table 3-6 RU PSU LED Specifications
ADX DAS-Module Specifications
Power
Solid Green
Module power is ON
OFF
Module power is OFF
CHG STS
Solid Yellow
No AC power detected and ADRF-BBU is being used
Blinking Green
ADRF-BBU is being charged
Solid Green
Completely Charged
OFF
Battery is not connected
LOW BATT
Solid Yellow
Low Battery alarm exist in the PSU
Solid Green
No Low Battery alarm is present in the PSU
AC FAIL
Solid Yellow
AC Fail alarm exist in the PSU
Solid Green
No AC Fail alarm is present in the PSU
DC FAIL
Solid Yellow
DC Fail alarm exist in the RFU
Solid Green
No DC Fail alarms is present in the PSU
3.2.3.2.2 AC Input On/Off Switch, AC Input Port and AC Input Selection Switch
AC IN
(A=AC_L,B=AC_N,C=F.G)
AC SELECT
OFFOFF
POWER S/W
Figure 3-34 RU PSU Power Switch View
The AC Power on/off switch is located at the rear of the ADX-R-PSU-30. The ADX-R-PSU-30 can be operated at
the 110V AC or 220V AC. The AC Input Voltage should be properly set by the user.
3.2.3.2.3 Battery Backup Port and Battery Backup Switch