User's Manual Part 2


AdvancedRFTechnologies,Inc.  54

6.2.2 RUInstallationProcedure
CAUTION: ADXDASRUshouldbeinstalledinsidebuildingonly.

6.2.2.1 InstallingaADXDASRUinarack
IftheADXRUchassisisbeingwallmountedthenallowclearanceof3”(76mm)frontandrear,and2”(51mm)
onbothsidesforaircirculation.Notoporbottomclearanceisrequired.
When ADX DAS RU mounts in a standard
 19” equipment rack, rack or wall type fan is needed for heat
dissipation.Theracktypefan(ADX‐R‐FAN)musthaveatleast1.75"ofclearance.

 Consideration:
‐ Eightmountingholesarelocatedon4cornersofADXRUtoattachittothe19”rack.TheADX
RUmustbe
securelyattachedtosupporttheweightoftheADX‐RUunits.
 Mountprocedure
‐ ThefollowingstepsshouldbefollowedwhilemountingtheADX‐RUunits
 DetachthewallmountbracketlocatedatthebaseoftheADX‐RUchassis
 VerifythattheRU
andMountingholeareingoodcondition
 ScrewtheADXDASRUtothe19”rack
 MakesuretheADXRUissecurelyattached
 ConnecttheGNDcable
 ConnecttheRFcable
 ConnectthePower
 ConnecttheOpticcable
