User's Manual Part 2


AdvancedRFTechnologies,Inc.  79

Table8‐11 DescriptionforRUCommissioningstatus
Status Display Description
InstalledStatus
Installed Textisblack
Not‐Installed Textisgray
CommissioningStatus
Success Green
Failornotyet Gray
8.2.2.5.3 Alarm
Table8‐12 AlarmStatus(Status‐RUHub)
Alarm Severity Description
System
LinkFail SoftFail
Presentwhenamodulecannotcommunicatewiththe
NMS
SystemHalt HardFail
Systemwillgointoa“SystemHalt”statewhenahard
failalarmdoesnotclearafter10checks.SystemHalt
canonlybeclearedwithapowercycle,reboot,or
factorysettings.
PowerAlarm
ACFail SoftFail ACpowerisnotwithinparameters.
DCFail SoftFail DCpowerisnotwithinparameters.
OverCurrent HardFail
TotalcurrentofRUishigherthanthethresholdlevelfor
overcurrentalarm
BatteryLow SoftFail
VoltageofbatteryconnectedtoRUPSUislowerthan
thedefinedthreshold
8.2.2.6 Status–Remotemodule

Figure8‐28 Status–RemoteModule