User's Manual Part 2


AdvancedRFTechnologies,Inc.  59

6.2.3 ADX‐H‐OEUInstallationProcedure
CAUTION: ADX‐H‐OEUshouldbeinstalledinsidebuildingonly.

6.2.3.1 InstallingaADX‐H‐OEUinaRack
TheADX‐H‐OEUmountsinastandard 19”(483mm)equipmentrack.Allowclearance of3”(76mm)frontand
rear,and2”(51mm)onbothsidesforaircirculation.Notoporbottomclearanceisrequired.

 Consideration:
‐ Fourmounting
holesarelocatedon4cornersofADX‐H‐OEUtoattachittothe19”rack.TheADX‐H‐OEU
mustbesecurelyattachedtosupporttheweightoftheunit.
 Mountprocedure
‐ ThefollowingstepsshouldbefollowedwhilemountingtheADX‐H‐OEU
 Detachthe
wallmountbracketslocatedatthebaseoftheADX‐H‐OEU
 VerifythattheOEUandmountingholeareingoodcondition
 ScrewtheADX‐H‐OEUtothe19”rack
 MakesuretheADX‐H‐OEUissecurelyattached
 ConnecttheGNDcable
 Connect
theRFcable
 ConnectthePower
 ConnecttheOpticcable
