User's Manual Part 2


AdvancedRFTechnologies,Inc.  58

6.2.2.3 WallmountinganADXRemoteModule
 Mountprocedure
‐ ThefollowingstepsshouldbefollowedwhilemountingtheRemoteModule

 VerifythattheRUandMountingholeareingoodcondition
 SeparatethewallmountbracketfromtheSub‐RU
 Placedthewallmountbracket
againstthewallandmarkoffthemountingholes
 Drillholes(4holes,6Φmm)intheinstallationsurfacetheninserttheenclosedanchorbolts
 Boltthemountingbrackettothewall
 InstalltheSub‐RUtothemountingbracket
 FastentheSub‐RUtothemountingbracketusing
theincludedscrews
 VerifythattheRemoteModuleissecurelyattached
 ConnecttheAntennacable
 ConnectthePower
 ConnecttheOpticcable(ifapplicable)

Figure6‐7 RemoteModuleWallMountInstructions
