User's Manual Part 2


AdvancedRFTechnologies,Inc.  56

6.2.2.2 WallmountingtheADXDASRU
If the ADX RU chassis is being mounted to a wall, then allow clearance of at least 16” (406mm) on the top
(front side of RU), 2” (51mm) on the bottom (rear side of RU) and 2” (51mm) on both sides and front for
 air
circulation.

 Mountprocedure
‐ ThefollowingstepsshouldbefollowedwhilemountingtheADXRU

 VerifythattheRUandMountingholeareingoodcondition
 PlacetheRUchassisupagainstthewallandmarkoffthemountingholes
 Drillholes(4holes,18Φmm,
50mmdepth)intheinstallationsurfaceandinserttheanchorbolts
 BolttheRUchassistothewall
 InstalltheindividualSub‐RUinsideofthechassis
 MakesuretheRUchassisissecurelyattached
 ConnecttheRFcable
 ConnecttheAntennacable
 Connectthe
Power
 ConnecttheOpticcable

Figure6‐5 ADX‐RUWallMountInstructions