User's Manual Part 1


AdvancedRFTechnologies,Inc.  27

3.1.1.2 EthernetPort
TheEthernetportcanbeusedtocommunicatedirectlywiththeADXDASusingaRJ‐45crossovercableorcan
alsobeusedtoconnecttheADXDAStoanexternalmodembox.

Figure3‐4 EthernetPort


3.1.1.3 Host/RemoteSwitch
TheHost/RemoteSwitchallowstheusertoswitchthedefaultRepeaterIP,SubnetMask,andGatewayofthe
repeatertoan alternativesetup.These settingscan beadjustedbylogginginto theADX DASinHOSTmodeand
configuringthesettings
undertheModemBoxSettingsectionundertheInstallPageofNMS.
Oncethesettingsare set,flippingtheswitch totheREMOTE position will reboot NMS module withthe new
alternatesettings.PleasenotethatwhentheNMS issetto theREMOTE position, DHCP isdisabled and theNMS

willnotautomaticallyassignanIPaddresstoanydevicethatconnectsdirectlytotheNMS.


Figure3‐5 Host/RemoteSwitch
 HostIP:192.168.63.1(FixedIP,unabletomodifythisIPaddress)
 RemoteIP:192.168.63.5(DefaultIP,butcanbemodifiedinHostmode)
3.1.1.4 HEView/RUViewSwitch
TheHEView/RUViewSwitchallowstheusertodisabletheperiodicmonitoringperformedby
theNMS.Inthe
HEviewmode,theNMSmonitorsthestatusofallsubordinateunitsconnected toNMSbutwhenswitchedtoRU
view the NMS does not monitor the subordinate units.RU View mode will allow the user to go to a RU and
monitor/control the HE.If the
NMSisset totheHE Viewmodeand triestoconnecttoaRUtomonitortheHE,
data collisions between the NMS and RU may prevent the user from properly monitoring or configuring the HE
whenattheRU.

Figure3‐6 HEView/RUViewSwitch
 