User's Manual


AdvancedRFTechnologies,Inc.  49

6.2.1.2 WallmountingtheADXDASHE
If the ADX HE chassis is being mounted to a wall, then allow clearance of at least 17” (430mm) on the top
(frontside ofHE)and 2” (51mm) on thebottom(rear side ofHE) and2” (51mm)on both sides andfront
 for air
circulation.

 Mountprocedure
‐ ThefollowingstepsshouldbefollowedwhenwallmountingtheADXHE
 VerifythattheHEandMountingholeareingoodcondition
 PlacetheADXHEagainstthewallandmarkofthemountingholes
 Drillholes(4holes,18Φmm,
50mmdepth)intheinstallationsurfaceandinserttheanchorbolts
 BolttheADXHEtothewall
 MakesuretheADXHEissecurelyattached
 ConnecttheGNDcable
 ConnecttheRFcable
 ConnectthePower
 ConnecttheOpticcable

Figure6‐2
 ADXHEWallMountInstructions