Installation Guide

During the installation, some panels will need to be cut to fit and the attaching flange will need to be
removed. To remove the flange, carefully cut off with snips. This may produce sharp edges so handle with
care. Pieces without the attaching flange will need to be installed with adhesive. In order to achieve a good
bond, a non-painted, clean flashing material must be attached to the structure first. After the bonding
surface has been installed, use a heavy duty construction adhesive such as PL Premium or DAP DynaGrip
Max to install the Adorn pieces. Additional temporary support may be needed until adhesive cures.
To install a sill under a window, carefully
remove the attaching flange and glue with a
heavy duty construction adhesive. Place
adhesive to the back and the bottom of the sill
piece being installed.
Our product is designed to allow natural
movement that protects from freezing,
thawing, and settling. If you use adhesive on
the Adorn panels, only place in the noted area
to allow for drainage.
If the project requires corners, install
the corner first and work out both
sides. Corners should be installed with
each course. Each corner piece needs
two screws or nails to securely attach.
Inside corners use the same corner
pieces reversed.
Fig. 2
Window