Should you prefer to speak with a customer service representative, you may call toll free: 1-855-372-2315 ere DECOR”
Guidelines FAILURE TO FOLLOW THESE WARNINGS WHEN IN USE COULD RESULT IN INJURY « Dio not stand on the item or use as a step ladder « Do not use this item unless all bolts and screws are firmly secured and fastened. » Chick ail bolts and screws every 90 days. As necessary frighten if any are loose. « Lift up then move. Pushing over or dragging this product can result in an injury or cause damage to the floor ard piece.
WARNING: DQ NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF INJURY. Pr-Assembly Preparation: Please read through this instruction booklet before beginning assembly of this item. Two adults are recommended for assembly. « Clear out the space for assembly and lay out all parts on Farts List, extra room will allow you to easily determine if all the pieces dre present. « Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
Parts List Symbolism © Bolts(3) ® Bolts(6) MEX L5H M8x20imm Mexico Metal Washer (8) ® Spring Washer {8} ® Allen Key (1) Bx16x 1.
Step 1 Attach Headboard Legs (2) to the Headboard (1). Secure the legs using MBx20mm Bolts(B) and tighten using the Allen Key (F).
Step 2 Attach the side rails {3)x2 to the Headboard Legs (2) and Foot hoard (4). Then secure by using Metal Washers (D), Spring Washers (E) and M8x20mm Belts (B). Tighten with Alien Key {F) (see below image).
Step 3 Attach the Cross Bar (5) into Side Rails (3) as shown in the image using MEx 15mm Bolts (A). Tighten with the Allen Key (F).
Step 4 Attach the Center Rail (6) to Crass Bar {8} using ard Mexico Bolt (A) and tighten with the Allen Key (F).
Step 5 1. Attach Leveler (Ij to Support Legs {7}. 2. Attach Support Leg Center Rail (8), secure using Mexicali Bolt (C) then tighten with Allen Key {FL 3. Adjust the Height of Legs (7) th suitable height.
Step 6 10 Attach the Last Cap-double Head (5) x4 on Center Rail (6). 20 Lay all the slate (8) crass the base of the bed, making chive they are the right way og {convex side fating up with the ribbon on the underside) Insert the offend slat (pinto Plastic Cap-double Head {5} xd Insertions the Plastic Cap-single Head end of Slat {8p Zither secure to the hole on Side Rail (3% as below image.
Step 7 Periodically (every 90 days) make sure that the bolts are fully tightened. ATTENTION : Be certain that all bolts are fully tightened before using bed.
Limited Warranty The manufacturers products are warrantied against defects in material and workmanship while caned by the "Original Purchaser”. The term “Original Purchaser” is defined as the party or entity which purchases this manufacturer's furniture from an authorized retailer as shown by the original sales receipt.
