Manualshelf

User Manual

ManualsBrandsADOP ADVANCED OPTICAL TECHNOLOGY ManualsComputers & AccessoriesSFP+ to RJ45 Copper Module - 10GBase-T Plus Transceiver for Cisco SFP-10G-T-S, Ubiquiti, Netgear, Supermicro, QNAP, Broadcom, MikroTik S+RJ10, Avago, up to 30m
123456789
17
VEET
Transmitter Ground (Common with Receiver Ground)
1
18
TD+
Transmitter Non-Inverted DATA in. AC Coupled.
19
TD-
Transmitter Inverted DATA in. AC Coupled.
20
VEET
Transmitter Ground (Common with Receiver Ground)
1
Notes:
1. Circuit ground is connected to chassis ground
2. PHY disabled on T
DIS
> 2.0V or open, enabled on T
DIS
< 0.8V
3. Should be pulled up with 4.7k - 10k Ohms on host board to a voltage between 2.0 V and 3.6 V.
MOD_DEF(0) pulls line low to indicate module is plugged in.
4. LVTTL compatible with a maximum voltage of 2.5V.
Figure 1. Diagram of host board connector block pin numbers and names