User's Manual

2. Insert two AA Alkaline Batteries into the battery compartment.
3. Replace the cover carefully.
 Once the batteries are place correctly in the mouse, the optical LED located at
the bottom of the mouse will light up.
Connect the Mouse
To connect to a USB port (Windows 98 or higher required).
Connect the USB receiver to the USB port on the computer.
To connect to a PS/2 port
TURN OFF your computer before installation.
1. Connect the PS/2 adapter to the USB receiver.
2. Insert the receiver into the PS/2 port on the computer.
3. Turn on your computer.
If you work under Windows environment, you may be prompted to insert the Windows
software CD. Please insert this CD into the computer’s CD-ROM when you are asked to
do so and follow the on screen instructions.
4. The battery detection system and middle wheel indicator light will warn you when
the battery power is low and require replacing.
Establishing a Communication Link
First of all, please find out if you bought a 400 cpi or 800 cpi mouse. (Please refer to
the label on the box).
For a 800 cpi mouse
1. After you insert the receiver to your computer, the LED on the receiver will NOT
flash;
2. Press the ID button of your receiver and the LED of the receiver will flash slowly;
3. Press the ID button on the back of your mouse in 2 minutes once the LED of the
receiver starts to flash;
4. Once the receiver links with the mouse successfully, the LED on the receiver will
blink quickly and then stop blinking.
If your RF Optical Mouse is disturbed by the neighbour mouse, please repeat the
procedure 2 to 4 for better performance.