User Guide

Using Help | Contents | Index Back 105
Adobe Premiere Pro Help Assembling a Sequence
Using Help | Contents | Index Back 105
This section covers using both views’ controls for cueing and playing back footage.
Controls for setting In and Out points and for adding or removing frames from a sequence
are covered in
“Using Monitor controls to perform three-point or four-point edits” on
page 132 and “Removing parts of a sequence” on page 146.
Most playback controls have keyboard equivalents. However, when you want to use
keyboard shortcuts to control playback, first make sure that the view you want is active.
Simply click the video image in the view you want to activate. When a view is active, the
Monitor window displays blue bars above and below the video display area.
You can also view frames by using the Monitor window’s time display. The number at the
bottom left of each view’s video shows the current time for that view. The number next to
the Duration icon
below each view’s video indicates duration. The duration is the time
difference between the In point and the Out point set for the corresponding view. When
no In point is set, the starting time of the clip (for the Source view duration) or of the
sequence (for the Program view duration) is substituted. When no Out point is set, Source
view substitutes the ending time of the clip to calculate duration, and the Program view
substitutes the ending time of the last clip in the sequence to calculate duration.
Playback controls in the Monitor window
A. Go To In point B. Go To Out point C. Play In point to Out point D. Go To Previous Marker
E. Frame back F. Play/Stop G. Frame forward H. Go To Next Marker I. Loop J. Jog disk K. Shuttle
slider
To play the Source or Program view:
Do any of the following:
• Click the Play button , or press L or the Spacebar. (To stop, click the Stop button or
press K or the Spacebar. The button and the Spacebar toggle between Play and Stop.)
• To play in reverse, press J.
• To play from the In point to the Out point, click the Play In To Out button .
• To play an entire clip or sequence repeatedly, click the Loop button , and then click the
Play button . Click the Loop button again to deselect it and prevent looping.
• To play from the In point to the Out point repeatedly, click the Loop button , and then
click the Play In To Out button . Click the Loop button again to deselect it and
prevent looping.
EC DA B GF IH KJ