User Guide

Anchor Point Specifies the point, in an x,y coordinate, around which the image will be
scaled or skewed.
Position Specifies the location, in an x,y coordinate, of the center (anchor point) of the
clip.
Scale Height Scales height up or down as a percentage of the source clip height.
Scale Width Scales width up or down as a percentage of the source clip width.
Uniform Scale Scales height and width proportionately.
Skew Specifies skew amount.
Skew Axis The axis on which the skew is based. Changing the axis has no effect if Skew
is
0.
Rotation Specifies the number of complete rotations and degree that the clip rotates.
Opacity Specifies the degree of transparency of the image, in percentages.
Note: Transform is an Adobe After Effects effect that includes the Shutter Angle control
and Use Composition option; both of those controls apply only in Adobe After Effects.
Twirl
The Twirl effect rotates a clip around its center. The image is rotated more sharply in its
center than at the edges. You can set the twirl angle from –999 to +999.
Vertical Flip
The Vertical Flip effect flips a clip upside down. Keyframes cannot be applied to this effect.
Vertical Hold
The Vertical Hold effect scrolls the clip upward; the effect is similar to adjusting the vertical
hold on a television set. Keyframes cannot be applied to this effect.
Wave
The Wave effect distorts a clip to make it wave-shaped.
Number of Generators Specifies the number of waves, which can range from 1 to 999.
Using Help | Contents | Index Back 279
Adobe Premiere Pro Help Applying Effects
Using Help | Contents | Index Back 279
Wavelength Specifies the distance from one wave crest to the next, using values from 1
to 999.
Amplitude Specifies the height of the wave, using values from 1 to 999.
Randomize Randomly selects a value between the minimum and maximum wavelength
and amplitude values; otherwise, the waves are of a uniform amplitude and frequency.
Scale Controls the magnitude of the distortion, both horizontally and vertically. A setting
of 0 provides an undistorted image.
Type Specifies Sine (rolling), Triangle (pointed crests), or Square (square crests).
Undefined Areas Specifies how to treat blank portions of the frame where the clip was
pulled away from the edges. The Wrap Around option wraps the image from the opposite
side of the frame to fill the space; the Repeat Edge Pixels option extends the colors of the
pixels along the edge of the clip.
Wind
The Wind effect distorts a clip to make it look as though wind were blowing pixels off the
surface of the clip. You can select the amount of distortion by selecting the Wind, Blast, or
Stagger method. You can also change the direction of the wind.
ZigZag
The ZigZag effect distorts a clip radially.
Amount Represents the magnitude of distortion; type a value from –100 to +100.
Ridges Represents the number of direction reversals of the zigzag from the center of the
clip to its edge; type a value from 1 to 20.