Operation Manual

168
Selecting
Last updated 9/13/2015
2 Select the Refine Selection Brush tool. Place the cursor inside the selection you just made, with the inner circle inside
the selection edge.
Important points while using this tool:
• Four modes are available: Add, Subtract, Push, and Smooth
• Add ( ) and Subtract ( ) are the modes to manually add and subtract to and from selections
• With Push ( ) mode:
• Placing the cursor inside a selection expands the selection within the outer circle to snap to the first image
edge found
• Placing the Cursor outside the selection contracts the selection within the outer circle to snap to the first
image edge found
• Smooth ( ) mode will help you smoothen the selection made
3 Depending on the mode that you selected in Step 2, the selection grows, diminishes or is fine-tuned as desired. For
example, choose the Push mode, position the inner circle of the cursor at the current selction and click to 'push' the
selection away from the cursor. If you push the selection too far, position the cursor outside the selection and gently
push the selection inward.