User Guide

563

ADOBE GOLIVE CS2

User Guide

• Scratch Density Controls the number of scratches that are drawn on each frame and the frequency with which

they appear.

• Scratch Duration Specifies the maximum number of frames in which each scratch appears.

• Scratch Width Specifies the maximum width, in pixels, of a scratch.

General Convolution Applies a general-purpose convolution effect to a single track. The effect that results is deter-

mined by the values of the kernel parameters of the effect. The kernel for this convolution is a 3-by-3 matrix of values

consisting of cells 1 through 9.

The convolution algorithm examines every pixel of the source and the eight pixels surrounding it. These values are

multiplied by the appropriate values in the cells and summerized. This sum is then used as the value of the corre-

sponding destination pixel.

HSL Balance Lets you independently adjust the hue, saturation, and lightness channels of a single track. The HSL

balance filter effect has three parameters:

• Hue Specifies the hue channel value of each pixel.

• Saturation Specifies the saturation channel value of each pixel.

• Lightness Specifies the lightness channel value of each pixel.

Lens Flare Produces a sunspot effect. The Lens Flare filter has two options: Intensity And Flare Center, and Flare

Type. The Intensity And Flare Center option has three parameters:

• Size Specifies the flare center size. When 1.0 is a small sunspot in the center of the image, and the increasing values

expand the flare until the flare covers the entire image at 2.0.

• Brightness Specifies the brightness of the flare, where 0.0 is transparent and 1.0 is the most opaque.

• Flare Center Specifies the horizontal and vertical motion dispersion of the flare using the x and y axes settings.

• Flare Type Displays the type of flare image being used.

RGB Balance Lets you independently adjust the red, green, and blue channels of a single track. The RGB balance

filter has three parameters:

• Red multiplier Specifies the red channel value of each pixel.

• Green multiplier Specifies the green channel value of each pixel.

• Blue multiplier Specifies the blue channel value of each pixel.

Sharpen Specifies the degree of sharpening from 1 (least) to 7 (most). The higher the value, the faster the effect runs

and the greater the degree of sharpening.