User Guide

31
ADOBE ATMOSPHERE
User Guide
To select a single object or connector:
1 Select the select tool () or the group select tool ().
2 In the Tool Inspector palette, specify the selection type:
• Objects to allow the selection of objects or groups only. This option prevents the
selection of connectors.
• Connectors to allow the selection of connectors only. This option prevents the selection
of objects and groups.
3 Do one of the following:
• Click the object or connector you want to select.
• Drag a marquee border around the object or connector you want to select.
Note: When you click to select an object, either the object or its connectors are selected, but not
both at the same time. When you drag a marquee to select an object, both the object and its
connectors are selected at the same time.
To select grouped objects:
1 Select the select tool ().
2 In the Tool Inspector palette, make sure that the Objects mode is chosen from the Select
menu.
3 Click or drag a marquee border around the grouped object you want to select.
To select multiple objects, groups, or connectors:
Do one of the following:
• Shift-click additional objects, groups, or connectors.
• Drag a marquee border around the objects, groups, or connectors you want to select. If
there are undesired objects overlapping the objects you want to select, hold down Ctrl and
drag a marquee around the desired objects. The Ctrl key prevents you from selecting
objects that are located where you first click to begin dragging the marquee.
atmosphere.book Page 31 Wednesday, March 21, 2001 6:14 PM