User`s manual

Driver Installation • 37

4.2 VGA Drivers Installation

This section describes the VGA driver installation for the on-board VGA

controller Intel 815E GMCH2. The relative drivers are located in

X:\PXI_Platform\PXI Controller\PXI-3710_3710F\815E VGA

Drivers

of the ADLINK All-In-One CD, where X: is the drive letter of the

CD-ROM drive. The VGA drivers for Windows 98, Windows NT, and

Windows 2000/XP are included.

Windows 98/2000/NT/XP may try to install the standard VGA driver. To

ensure compatibility, manually install the latest driver, which is included in the

ADLINK All-In-One CD. To update to the new driver, follow these

procedures:

1. Boot Windows and execute the setup program under this directory:

X:\PXI_

Platform\PXI controller\PXI-3710_3710F\815E

VGA Driver\

2. The VGA driver will automatically be installed to the system.

3. Restart the system.

Note: After installing the VGA/AGP drivers in Windows NT system, you may find

the drivers do not work correctly. This may be caused by not installing the

Windows NT service pack beforehand. Make sure to install Windows NT

service pack 6 or higher version to enable AGP capability.

4.3 LAN Driver Installation

This section describes the LAN driver installation procedures for the

on-board Intel 82562EM Ethernet controller. The Intel 82562EM is a 32-bit

10/100 Mbps Ethernet controller for PCI local bus-compliant computers. It

supports bus mastering architecture and Auto-negotiation features which

make it possible to combine a common Ethernet cable (RJ-45 connector with

twisted-pair cabling) for use with both 10Mbps and 100Mbps connections.

The relative drivers are located in the following ADLINK All-In-One CD