User`s manual

Introduction • 13
1.4 Specifications
General CompactPCI Features
PICMG 2.0 CompactPCI specifications R3.0 compliant
PICMG 2.1 R1.0 CompactPCI Hot Swap specifications compliant
CPU
Supports Socket370 CPUs up to 1.4GHz, including:
Intel socket370 Pentium III, Celeron, and VIA C3 CPU
Front side bus (FSB) frequency: 100/133MHz
Chipset
Intel 815E chipset (in Intel Embedded Roadmap)
VGA
3D graphics visual enhancement
24-bit 230MHz RAMDAC
Up to 1600x1200 resolution (256 colors at 85Hz refresh rate)
BIOS
Award PnP BIOS advanced by ADLINK
Write protection and anti-virus capabilities
DMI BIOS Support
Supports Intel pre-boot execution environment (PXE)
Optional remote console, upon OEM request
Optional customized power-on screen, upon OEM request
Host Memory
Two 144-pin SO-DIMM sockets, supporting maximum 512MB
un-buffered SDRAM module
IDE Ports
Primary IDE bus: one 44-pin ATA-100 EIDE interface on board to
support one slim type EIDE hard disk drive.
Secondary IDE bus: provides one 50-pin CompactFlash type II
connector (CF1: jumper-selectable as master or slave) and one
40-pin ATA-100 IDE connector on the front panel
USB Interface
Three USB ports, Specification Rev. 1.1 compliant
USB-1, 2 on front panel
USB-3 on the rear I/O transition module, PXD-R3000.
Over-current protection with polyswitch resetable fuse @500mA
On-board Ethernet
One RJ-45 Ethernet port on the front panel
LAN controller integrated in ICH2 and Intel 82562EM PHY