User`s manual

Introduction • 7
1.2 Features
1.2.1 PXD-3710/3710F Features
Standard 3U PXI form factor
PICMG 2.0 CompactPCI specification R3.0 compliant
PICMG 2.1 R1.0 CompactPCI Hot Swap specification compliant
Socket-370 Pentium III, Celeron, or VIA C3 CPU, FSB 100/133
(CPU frequency up to 1.4GHz)
Two 144-pin SO-DIMM sockets supporting up to 512MB RAM
One internal 44-pin EIDE for 2.5-inch hard disk, and one 40-pin
EIDE connector on the front panel for HDD or optical storage
device connection
Two CompactFlash interfaces:
Internal CF1 uses the bootable IDE, and could be a hard disk
replacement
The CF2 on the front panel is hot swappable, and could be a
floppy disk drive replacement for higher capacity mobile storage
media
VGA output supports resolution up to 1600x1200.
One 10/100Mb Ethernet port, two USB R1.1 ports, one serial port,
and one parallel port are available on the front panel.
The serial port COM1 is jumper selectable for RS-232/422/485
(With RS-485+ Auto-Direction Control).
Programmable watchdog timer and hardware monitoring
Built-in 2.5 inches low profile HDD, easy to install
Supports 7 bus-master peripherals
Optional floppy disk drive (PXD-3710F)
1.2.2 PXD-R3000 Features
Rear IO transition module for PXD-3710/3710F
One USB port, one serial port (COM2)
DVI connector on the panel. The DVI transmitter supports up to
165M pixels/sec and up to 1600x1200 (UXGA) resolution display
Build-in 24-bit CMOS/TTL flat panel display (FPD) output,
supports VGA, SVGA, XGA and dual pixel SXGA
Optional LVDS output on rear I/O to support pixel data
transmission to FPD, up to UXGA resolution (For OEM request
only).