User`s manual

52 Appendix A
PXI-3920/3910
User’s Manual
dest
Destination Trigger Routing.
halfway
Halfway Point Trigger Routing. This parameter is used only
when users want to route the software-generated trigger signal
to the SMB connector on the faceplate. In this case, users
should set the halfway as one of the trigger bus lines. Other-
wise set the halfway as PXI_TRIG_VAL_NONE.
@ Return Codes
ERR_NoError
ERR_BoardNoInit
ERR_Set_Path
Available value Description
PXI_TRIG_VAL_SMB SMB connector on the faceplate
PXI_TRIG_VAL_TRIG0 PXI trigger bus #0
PXI_TRIG_VAL_TRIG1 PXI trigger bus #1
PXI_TRIG_VAL_TRIG2 PXI trigger bus #2
PXI_TRIG_VAL_TRIG3 PXI trigger bus #3
PXI_TRIG_VAL_TRIG4 PXI trigger bus #4
PXI_TRIG_VAL_TRIG5 PXI trigger bus #5
PXI_TRIG_VAL_TRIG6 PXI trigger bus #6
PXI_TRIG_VAL_TRIG7 PXI trigger bus #7
Available value Description
PXI_TRIG_VAL_NONE No halfway point
PXI_TRIG_VAL_TRIG0 PXI trigger bus #0
PXI_TRIG_VAL_TRIG1 PXI trigger bus #1
PXI_TRIG_VAL_TRIG2 PXI trigger bus #2
PXI_TRIG_VAL_TRIG3 PXI trigger bus #3
PXI_TRIG_VAL_TRIG4 PXI trigger bus #4
PXI_TRIG_VAL_TRIG5 PXI trigger bus #5
PXI_TRIG_VAL_TRIG6 PXI trigger bus #6
PXI_TRIG_VAL_TRIG7 PXI trigger bus #7