User`s manual

Hardware Installation 9

GIE64+

3 Hardware Installation

The following describes installation of the GIE64+ module on the

PCI express bus.

1. Remove the computer cover according to the computer

manual..

2. Remove the slot cover (if any), retaining the fixing screw.

3. Carefully position the GIE64+ in the selected PCI

express slot. If installing in a tower computer, align the

board with the board slots.

4. Press the board firmly but carefully into the connector.

5. Anchor the board with the screw.

6. Plug the cable into the PoE power connector.

7. Connect the device via a Gigabit Ethernet connector.

8. Power up the computer.

NOTE:

A vacant PCI express slot is required for installation of the

GIE64+ module; if none is available, remove a PCI express

board and note the slot number.

NOTE:

The GIE64+ can be installed in a PCI Express x4, x8, or x16

slot