User`s manual

Introduction 25
MXC-6300
1.6.13 DC Power connector
The DC power supply connector of the MXC-6300 is on the front
panel. The power supply connector consists of three pins, V+,
chassis ground, and V- from right to left respectively. V+ and V-
pins provide DC power input and the chassis ground pin allows
connection of the chassis to ground for better EMC compatibility.
The DC power input for the MXC-6300 allows a voltage input
range from 9 V DC to 32 V DC.
Table 1-14: DC Power Supply Connector Signals
NOTE:
NOTE:
Keyboard & mouse PS/2 connectors do not support hot-
plug capability.
WARNING:
Ensure that the DC power supply:
X is within the input voltage range defined in the
specification
X is stable and low-noise DC
X provides sufficient operating current
DC power supply over or under voltage, unstable, or of insuffi-
cient power may cause system instability and physical damage
Pin Signal
1V+ (DC_IN)
2 GND (CHGND)
3 V- (DGND)
PRELIMINARY