User`s manual

Getting Started 35
Matrix MXE-1000 Series
User’s Manual
3.4 Plug-in DC Power
Note: Before plugging DC power into the MXE-1005/1010/1020
controller, please make sure you have correct voltage
and polarity for your DC input. An improper input voltage
or polarity will cause system damage.
The DC power input connector of the MXE-1005/1010/1020 con-
troller is located on the rear panel. It consists of three pins, V+,
chassis ground, and V- from right to left respectively. The DC
power input accepts an input voltage from 6 VDC to 36 VDC. User
should connect the DC power as the figure showed below. Two
screws of the plug should be fastened to prevent the plug loosing.