User`s manual

ViewCreator Utility 51
Cross Line
Check the Cross Line check box in the Control Panel. A cross-
hair will appear in the center of the rectangle.
Tools
GPIO and LED
X Click Tool in the menu bar and select GPIO & LED to bring
up the GPIO dialog box. Select the port to access and
select the digital output value. Click either the write or read
button to write/read to/from the digital I/O ports.
X LED status is only supported with the cPCI Angelo series
card.
EEPROM
X Click Tool in the menu bar and select EEPROM to bring up
the EEPROM dialog box. Select the card you wish to
access, enter the offset and output values, then click the
Write button to write the value into the EEPROM. Enter the
offset value and click the Read button to read the value
from the EEPROM.
X Valid offset values are between 0 and 127. Valid output val-
ues are between 0 and 255. The value in the EEPROM will
not be erased when the system is powered off.
Software trigger
X Click Tool in the menu bar and select Software Trigger to
bring up the Trigger dialog box. Select the card to access
and set the interval of the trigger pulse output. Check the
ports you want to trigger simultaneously, and click the Trig-
ger button.
X The one shot pulse output voltage goes high (from 0V to
5V).