User`s manual

Installation Guide 29
3 Installation Guide
3.1 Hardware Installation
PCI-MP4S
Use the following steps to install the PCI-MP4S board on the PCI
bus:
1. Remove the computer cover using the instructions from
the computer manual.
2. Check that there is an empty PCI (32-bit) slot to accom-
modate the board. If there is no empty slot, remove a
PCI board from the computer to make room for the PCI-
MP4S board and note the chosen slot number (i.e. card
index).
3. Remove the blank metal plate located at the back of the
selected slot (if any). Keep the removed screw to fasten
the PCI-MP4S board after installation.
4. Carefully position the PCI-MP4S in the selected PCI slot
as illustrated below. If using a tower computer, orient the
board to suit the board slots.