Specifications

120 IBM Power 770 and 780 Technical Overview and Introduction
3.1 POWER Hypervisor
Combined with features designed into the POWER7 processors, the POWER Hypervisor
delivers functions that enable other system technologies, including logical partitioning
technology, virtualized processors, IEEE VLAN compatible virtual switch, virtual SCSI
adapters, virtual Fibre Channel adapters, and virtual consoles. The POWER Hypervisor is a
basic component of the system’s firmware and offers the following functions:
򐂰 Provides an abstraction between the physical hardware resources and the logical
partitions that use them
򐂰 Enforces partition integrity by providing a security layer between logical partitions
򐂰 Controls the dispatch of virtual processors to physical processors (See “Processing mode”
on page 131.)
򐂰 Saves and restores all processor state information during a logical processor
context switch
򐂰 Controls hardware I/O interrupt management facilities for logical partitions
򐂰 Provides virtual LAN channels between logical partitions that help to reduce the need for
physical Ethernet adapters for inter-partition communication
򐂰 Monitors the Service Processor and performs a reset or reload if it detects the loss of the
Service Processor, notifying the operating system if the problem is not corrected
The POWER Hypervisor is always active, regardless of the system configuration and also
when not connected to the managed console. It requires memory to support the resource
assignment to the logical partitions on the server. The amount of memory required by the
POWER Hypervisor firmware varies according to several factors. Factors influencing the
POWER Hypervisor memory requirements include these:
򐂰 Number of logical partitions
򐂰 Number of physical and virtual I/O devices used by the logical partitions
򐂰 Maximum memory values specified in the logical partition profiles
The minimum amount of physical memory required to create a partition will be the size of the
system’s Logical Memory Block (LMB). The default LMB size varies according to the amount
of memory configured in the CEC (Table 3-1).
Table 3-1 Configured CEC memory-to-default Logical Memory Block size
In most cases, however, the actual minimum requirements and recommendations of the
supported operating systems are above 256 MB. Physical memory is assigned to partitions in
increments of LMB.
The POWER Hypervisor provides the following types of virtual I/O adapters:
򐂰 Virtual SCSI
򐂰 Virtual Ethernet
򐂰 Virtual Fibre Channel
򐂰 Virtual (TTY) console
Configurable CEC memory Default Logical Memory Block
Greater than 8 GB, up to 16 GB 64 MB
Greater than 16 GB, up to 32 GB 128 MB
Greater than 32 GB 256 MB