User`s manual

6 Function Classes
PCIS-DASK
General Configuration Function Group
2.1 General Configuration Function Group
These functions initialize and configure data acquisition cards.
Register_Card Initializes the hardware and software
states of a NuDAQ PCI-bus data acqui-
sition card. This function must be called
before any other DASK library functions.
Release_Card Tells the DASK library that the regis-
tered card is not in use and can be
released. This function makes room for
a new card to register.
GetCardType Gets the card type of the device with a
specified card index.
GetCardIndexFromID Gets the card type and the sequence
number of the device with a specified
card ID.
GetBaseAddr Gets the I/O base addresses of the
device with a specified card index.
GetLCRAddr Gets the LCR base address (defined by
the PCI controller on board) of the
device with a specified card index.
SetInitPattern Sets the state of the initial or safety-out
pattern.
GetInitPattern Gets the state of relays set by the
onboard switches.
IdentifyLED_Control Controls identification LED.
2.2 Actual Sampling Rate Function Group
GetActualRate Returns the actual sampling rate the
device will perform for the defined sam-
pling rate value.