User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
System Resources 83
NuPRO-935A
Table B-5: IRQ Lines APIC Mode
Note (1): These IRQs can be used for PCI devices when onboard
device is disabled. If IRQ is from ISA, user must reserve IRQ for ISA in
BIOS setup menu.
Note (2): BIOS does not open IRQ 9 setting for ISA bus.
18 N/A
PCI Slot 1/2/3/4, PCIE
Port 0/1/2/3/4/5 UHCI
Controller 3, PEG Root
Port, SATA Host
controller, SMBus
Controller, Thermal
Controller, EHCI
Controller #2
Yes
19 N/A
PCI Slot 1/2/3/4, PCIE
Port 0/1/2/3/4/5 UHCI
Controller 2/7, PEG Root
Port, SATA Host
controller, SATA Host
controller#1,
Yes
20 N/A
ICH9 internal GBE
controller
No
21 N/A UHCI Controller 5 No
22 N/A ICH9 HDA No
23 N/A
UHCI Controller 1, EHCI
Controller 1
No
IRQ#
Typical Interrupt
Resource
Connected to Pin Available