User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
48 BIOS Setup
5.3.2 IDE Configuration
You can use this screen to select options for the IDE Configuration
Settings. Use the up and down < Arrow > keys to select an item.
Use the < + > and < - > keys to change the value of the selected
option. A description of the selected item appears on the right side
of the screen. The settings are described on the following pages.
An example of the IDE Configuration screen is shown below.
SATA Configuration
This item specifies which mode the SATA channels should be
initialized in. The settings are Disabled, Compatible and
Enhanced. When running in Compatible mode, SATA channel
can be configured as a legacy IDE channel.
IDE Master/Slave
Select one of the hard disk drives to configure it. Press
< Enter > to access its sub menu.