User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
44 BIOS Setup
F10 The < F10 > key allows you to save any changes you have made
and exit Setup. Press the < F10 > key to save your changes. The
following screen will appear:
Press the < Enter > key to save the configuration and exit. You can
also use the < Arrow > key to select Cancel and then press the <
Enter > key to abort this function and return to the previous screen.
ESC The < Esc > key allows you to discard any changes you have made
and exit the Setup. Press the < Esc > key to exit the setup without
saving your changes. The following screen will appear:
Press the < Enter > key to discard changes and exit. You can also
use the < Arrow > key to select Cancel and then press the < Enter
> key to abort this function and return to the previous screen.
Enter The < Enter > key allows you to display or change the setup option
listed for a particular setup item. The < Enter > key can also allow
you to display the setup sub-screens.