User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
Driver Installation 39
NuPRO-935A
4.4 ISA Driver
Follow these instructions to install the ISA driver.
1. Open the Device Manager on your system.
2. Right click on ‘Other PCI Bridge Devices’.
3. A dialog box will appear. Select ‘Update Driver...’
4. The ‘Hardware Update Wizard’ dialog box will open.
Read the instructions and then click option 3, ‘No, not
this time’, then click ‘Next’ to continue.
5. The next screen will prompt you to search for the loca-
tion of the driver for your device. Click option 2, ‘Install
from a list or specific location (Advanced)’ and then
click ‘Next’.
6. Locate the following folder on the ADLINK All-in-One
DVD: X:\NuPRO\NuPRO-935A\ISA. Press ‘Next’ to
install the inf files.
7. After successfully installing the files, the ‘Hardware
Update Wizard’ will display the ‘Completing the Hard-
ware Update Wizard’ screen. Click ‘Finish’.
4.5 TPM Driver
Follow these instructions to install the TPM driver.
1. Locate the TPM driver from the directory
X:\NuPRO\NuPRO-935A\TPM\ and run Setup.exe to
start installation.
2. Follow the screen instructions to complete installation,
then restart the system if prompted.