User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
38 Driver Installation
4.2 Display Driver
This section describes the installation of the Intel® Graphics
Media Accelerator (GMA) 3000 driver.
To install the display driver:
1. Locate the display driver from this directory
X:\NuPRO\NuPRO-935A\VGA\, then double-click on
the Setup.exe file to start installation.
2. Follow screen instructions to complete installation, then
restart the system if prompted.
4.3 LAN Driver
Follow these instructions to install the LAN driver.
1. Locate the LAN driver from the directory
X:\NuPRO\NuPRO-935A\Ethernet\, then double-click
on the PRO2KXP.exe file to start installation.
2. Follow screen instructions to complete installation, then
restart the system if prompted.