User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
34 Getting Started
3.3 Installing the Power Connectors
Refer to Section 2.3 Onboard Connectors on page 18 for
detailed information on connectors and pin definitions referred to
below.
ATX 12V Power Connector
The NuPRO-935A requires +12V DC power connected to CN7 for
proper operation in either ATX or AT modes . If necessary, order a
ATX12V Convert Cable from ADLINK for use with Molex 4-pin
power connectors (P/N 30-00006-0000).
System Panel Connector
Before powering up the NuPRO-935A, connect the necessary sig-
nals from the backplane to the System Panel Connector (CN1).
The ATX Power Connector pin group (pins 6-10) and Power On
Button pin group (pins 19-20) must be connected for the system to
power up in ATX mode.