User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
Getting Started 29
NuPRO-935A
5. Position the CPU over the socket, then match the
notches on the CPU side with the alignment keys on the
socket. The golden triangle on the CPU must be posi-
tioned on the bottom-left corner of the socket .
6. Carefully place the CPU on the socket in a vertical
motion. The socket has tabs that accommodate your fin-
gers during installation .
WARNING:
The CPU fits the socket in only one orientation. DO NOT
force it into the socket to avoid damaging it.
Golden triangle
Notch
Alignment
key
Socket tab