User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
22 Hardware Information
Parallel Port (CN13)
HD Audio Daughter Board Connector (CN4)
Pin # Signal Pin # Signal
1 Line Printer Strobe 14 Auto-Feed
2 Parallel Data 0 15 Error
3 Parallel Data 1 16 Initialize
4 Parallel Data 2 17 Select
5 Parallel Data 3 18 Ground
6 Parallel Data 4 19 Ground
7 Parallel Data 5 20 Ground
8 Parallel Data 6 21 Ground
9 Parallel Data 7 22 Ground
10 Acknowledge 23 Ground
11 Busy 24 Ground
12 Paper Empty 25 Ground
13 Select 26 NC
Pin # Signal Function
1 GND Ground
2 AUD_BCLK Audio Clock
3 GND Ground
4 ICH_AUD_SDIN0 Audio Data Input
5P5V+ 5V
6 ICH_AUD_SDOUT Audio Data Output
7 P5V_AUD + 5V
8 P3V3_DVDD 3.3V
9 AUD_SYNC Audio Synchronous
10 AUD_RST-L Audio Reset
NOTE:
NOTE:
This connector is designed for use with the ADLINK DB-Audio2
daughter board.