User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
Hardware Information 17
NuPRO-935A
2.2 Board Layout
The illustrations below show the locations of connectors, slots,
and jumpers on the NuPRO-935A.
Figure 2-2: Connectors and Jumpers Pt. 1
Connector Description
1 DIMM1 240-pin DDR2 DIMM slot
2 DIMM2 240-pin DDR2 DIMM slot
3 CN1 System Panel connector
4 CN7 ATX 12V Power connector
5 FAN1 System Fan connector
6 FAN2 CPU Fan connector
7 JP5 Clear CMOS
8 CN17 LPC port connector
9 CN19 External Keyboard/Mouse connector
1
2
3
4
6
7
5
1
8
9