User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
Hardware Information 13
NuPRO-935A
2 Hardware Information
This chapter provides information on the NuPRO-935A board lay-
out, connector pin assignments, and jumper settings.
2.1 Rear Panel I/O Ports
Figure 2-1: Rear Panel I/O Ports
Connector Description
1 PS/2 KB/MS port
Connects a PS/2 mouse and keyboard
1
2
Gigabit LAN port
(RJ-45)
Provides Gigabit Ethernet connection
3
Gigabit LAN port
(RJ-45)
Provides Gigabit Ethernet connection
(not supported on NuPRO-935A/LV)
4 VGA port
This 15-pin port connects to a CRT or LCD
monitor.
5 USB 2.0 port
High-speed USB ports available for
connecting USB devices
NOTE:
NOTE:
1
A Mini-DIN PS/2 KB/MS connector is not supported on
boards with ordering numbers ending in “xx40” and higher. See
“PS/2 Keyboard/Mouse Port” below.
1
2 3 4
5