User`s manual
Table Of Contents
- NuPRO-935A
- Revision History
- Preface
- Table of Contents
- List of Figures
- List of Tables
- 1 Introduction
- 2 Hardware Information
- 2.1 Rear Panel I/O Ports
- 2.2 Board Layout
- 2.3 Onboard Connectors
- ATX 12V Power Connector (CN7)
- CPU Fan Connector (FAN2)
- System Fan Connector (FAN1)
- IDE Connector (CN10)
- Floppy disk drive connector (CN8)
- Parallel Port (CN13)
- HD Audio Daughter Board Connector (CN4)
- COM1 Connector (RS-422/485/485+) (CN6)
- COM1/COM2 Connector (RS-232) (CN5/6)
- USB 2.0 Connector (CN11-12)
- External Keyboard/Mouse Connector (CN19)
- Serial ATA Connectors (CN2-3)
- System Panel Connector (CN1)
- 2.4 Jumpers
- 3 Getting Started
- 4 Driver Installation
- 5 BIOS Setup
- Appendix A - Watchdog Timer
- Appendix B System Resources
- Important Safety Instructions
- Getting Service
Revision History
Revision Release Date Description of Change(s)
2.00 2008/08/29 Initial release
2.01 2008/10/29 Correct Board Layout (COM1/2)
2.02 2009/05/13
Update OS support, driver locations, add TPM
driver installation
2.03 2010/07/03
Correct BIOS Power Button Mode description;
correct CPU Fan connector, GbE connector,
Floppy connector pin definitions; correct COM1
connector label (CN6); correct memory and
heatsink/fan installation instructions; update
addresses
2.04 2011/04/26
Remove Mini-DIN PS/2 KB/MS and legacy
cables for boards with ordering numbers ending
in “xx40” and higher; update addresses