User`s guide

Device Driver Installation • 47
4.1 VGA Drivers Installation
This section describes the VGA driver installation for the onboard VGA
controller M69000. The relative drivers are located in
X:\CHIPDRV\VGA\69000 directory of the ADLINK CD: where X: is the
location of the CD-ROM drive. The VGA drivers for Windows 98/95,
Windows NT and Windows 2000 are included.
4.1.1 Driver Installation on Windows NT
Windows NT may install the standard VGA driver. We recommend you to
manually installed the most updated driver, which is shipped with the
ADLINK CD to guarantee compatibility. After installing Windows NT, update
to the newer driver by following these procedures.
1. From the Control Panel, double-click the Display icon.
2. Click the Settings tab, click Display Type…, click Change… button.
3. Insert the ADLINK CD and click Have Disk.
4. Browse the M69000 driver in the following path: X:\CHIPDRV\VGA\
69000\NT40, highlight oemsetup.inf, click OPEN. Click OK.
5. A windows will appear and will display chips Video Accelerator
(65545/48/50/54/55 68554 69000), click OK, then click Yes to continue.
6. An Installation Driver window will appears indicating a successful
installation, click OK to continue.
7. Click Close button.
8. Click Close button, then restart the computer to activate the new driver.
Note: After installing the VGA/AGP drivers, and you find the driver does
not work. This maybe due to not installing the NT service pack in
advance. We suggest installing NT service pack 4 or higher to
enable AGP capability.