User`s guide

Getting Started • 43
3.3 HDD Installation on Main Board
A slim-type 2.5-inch HDD can be mounted to the cPCI-6810/6820 main
board. If a HDD is pre-installed when you receive the cPCI-R6820 product
package, this section maybe skipped.
Step 1: Remove the PMC Key-bolt of the PMC slot #1.
Step 2: Screw the bolts on to the HDD; attach a 44-pin IDE cable.
Step 3: Install the assembly on to the board; tighten the 4 screws from the
bottom side of the main board to secure the HDD in to place.
Step 4: Attach the other end of the 44-pin IDE cable to CN4 on board.
3.4 HDD Installation on RTM
A 2.5 inches HDD or Flash Disk can be installed on the RTM directly. If a
HDD is pre-installed when you receive the cPCI-R6820, please skip this
section.
Step 1: Attach the IDE cable to the HDD or Flash Disk
Step 2: Put the HDD on component side of the RTM, align the HDD’s
mounting holes with the holes on the PCB.
Step 3: tighten the 4 screws from the bottom side of the RTM to secure the
HDD in to place
Step 4: Connect the IDE cable to the 44-pin connector CN4.
3.5 CF Installation on RTM
The CompactFlash Card (or called CF storage card) is widely applied in
digital consumer devices like PDA, Digital Camera and MP3 player.
Because of the CF anti-shock, anti-vibration, better environment tolerance,
low power consumption, small form factor and high reliability, it has been
widely accepted in mission critical embedded applications.
With the cPCI-6810/6820, the CF card is very easy to use; the CF card
socket is available on the cPCI-R6820, which is a rear transition module.