User`s guide

70 • Motion Creator
5.4.1 Linear Interpolation
: After setting motion parameters correctly in “Interpolation Parameter
Setting Frame”, you can enter the destination in this frame. Then click Run
button to start linear interpolation motion.
5.4.2 Circular Interpolation
The setting for circular interpolation mode has three additional parameters
in “Interpolation Parameter Setting Frame”. They are arc degree, division
axis and optimize option. Please refer to section 6.9 to set them.
After setting these parameters, you can enter the arc center and degree in
“Interpolation Command Frame”. Click Run button to start circular
interpolation motion.
5.4.3 Continuous Jog
: Continuous Jog means that when you press one directional button, the
axis will continuously move with an increasing speed. The longer you press,
the faster it runs. When you un-press the button, the axis will stop
immediately.