User`s guide

Installation • 9
2.3.2 PCI slot selection
Your computer will probably have both PCI and ISA slots. Do not force the
PCI card into a PC/AT slot. The PCI-8134 can be used in any PCI slot.
2.3.3 Installation Procedures
Read through this manual, and setup the jumper according to your
application
Turn off your computer, Turn off all accessories (printer, modem, monitor,
etc.) connected to computer.
Remove the cover from your computer.
Select a 32-bit PCI expansion slot. PCI slots are short than ISA or EISA
slots and are usually white or ivory.
Before handling the PCI-8134, discharge any static buildup on your body by
touching the metal case of the computer. Hold the edge and do not touch
the components.
Position the board into the PCI slot you selected.
Secure the card in place at the rear panel of the system unit using screw
removed from the slot.
2.3.4 Trouble shooting:
If your system won‘t boot or if you experience erratic operation with your
PCI board in place, it’s likely caused by an interrupt conflict (perhaps
because you incorrectly described the ISA setup). In general, the solution,
once you determine it is not a simple oversight, is to consult the BIOS
documentation that come with your system.