User`s guide

66 • VGA Driver Installation
5.1 Installing the Drivers for Windows 95
The following section describes the normal display driver installation
procedures for Windows 95. Use the following procedures when installing
the display drivers for Windows 95.
1. Click Start. Select Settings, then click the Control Panel icon.
2. Double click Display.
3. Click Settings.
4. Click Advanced Properties.
5. Click Change.
6. Click Have Disk ....
7. Insert the diskette/CD containing the 69000 VGA driver for Windows
95 to the floppy disk drive/CD-ROM drive, then type in A:\WIN95
(assuming drive A is your floppy disk drive) or type in
D:\NuPRO\NuPRO595\VGA DRIVER\WIN95 (assuming drive D is
your CD-ROM drive), and press Enter.
8. Select Chips and Tech. 69000 PCI/AGP, and then click OK. After the
files are copied, click Close.
9. Click Yes to restart your computer and for the new settings to take
effect.
5.2 Installing the Drivers for Windows 98
The following section describes the normal display driver installation
procedures for Windows 98. Use the following procedures when installing
the display drivers for Windows 98.
1. Insert the diskette/CD containing the C&T 69000 VGA driver for
Windows 98 to the floppy disk drive/CD-ROM drive, then run
CTW98600.exe. With ADLINK CD , this setup program is located in
\NuPRO\NuPRO595\VGA DRIVER\WIN98 directory
2. Click Next. After all procedures are completed, then click Finish.
3. Click Yes to restart your computer and for the new settings to take
effect.