User`s guide

•

BIOS Configuration

Reset Configuration Data

This field allows you to determine whether to reset the configuration data or

not. The default value is Disabled.

IRQ3/4/5/7/9/10/11/12/14/15, DMA0/1/3/5/6/7 assigned to

These fields allow you to determine the IRQ/DMA assigned to the ISA bus

and is not available to any PCI slot.

PCI IDE IRQ Map To

PCI-AUTO

BIOS will scan for PCI IDE devices &

determine the location of the PCI IDE device

and assign IRQ 14 for primary IDE INT#, IRQ

15 for secondary IDE INT#

PCI-SLOT1/2/3/4

BIOS assign IRQ 14 for primary IDE INT#,

IRQ 15 for secondary IDE INT# for the

specified slot

ISA

The BIOS will not assign any IRQs eve

n if PCI

IDE board is found. Because some IDE

boards connect the IRQ 14 & 15 directly from

ISA slot thru a cord . (This cord is called

Legacy Header)

Primary IDE INT#/Secondary IDE INT#

To tell which INT# does the PCI IDE board is using for its interrupts

Used MEM base addr

Select a base address for the memory area used by any peripheral that

requires high memory. The default setting is N/A.

u Load BIOS Defaults

This option allows you to load the troubleshooting default values

permanently stored in the BIOS ROM. These default settings are

non-optimal and disable all high-performance features.