Specifications

Command Set 3-33
3. 23. Write Source High/Low Values for Linear
Mapping
@Description
Write the source high/low limit values from input for linear mapping.
@Syntax
$(Addr)6(Data_L)(Data_H)<CR>
$ Command leading code.
(Addr) Address ID
6 Set the high/low limit values from input for linear
mapping .
(Data_L) Low limit input value for linear mapping. It must be
lower than the high limit input value. The format of
data is the same as input current range. The
minimum input value could equal to the minimum
input value of input current range. Data format is
with an + or - sign with five decimal digits and a
decimal fixed point.
(Data_H) High limit input value for linear mapping. It must be
higher than the low limit input value. The format of
data is the same as input current range. The
maximum input value could equal to the maximum
input value of input current range. Data format is
with an + or - sign with five decimal digits and a
decimal fixed point.
@Response
!(Addr)<CR>
or
?(Addr)<CR>
!
Command is valid.
(Addr) Address ID.
? Command is invalid.
(6014D)