User`s guide

20 • Connectors
3.14 Internal KB Connector
Connector for NUPRO-710 to Backplane KB Connector.
Pin Function
1 KB Clock
2 KB Data
3 Power Good
4 GND
5 +5V
3.15 Primary, Secondary IDE Connector
This connector supports the provided IDE hard disk ribbon cable. After
connecting the single end to the board. Connect the two plugs at the other
end to your hard disk(s). If you installed two hard disks, you must configure
the second drive to Slave mode by setting its jumpers accordingly. Please
refer to the documentation of your hard disk for the jumpers setting.
You may also configure two hard disk to be both Master using one-ribbon
cable on the primary IDE connector and another ribbon cable on the
secondary IDE connector.
KB Internqal
Connector
IDE1: Primary IDE Connector
IDE2: Secondary IDE Connector